EZBR-DUAL-AC

(3 customer reviews)

EZ-Bridge-AC – 5GHz 802.11ac 867Mbps, P2P Secure Bridge Pair with 2.4GHz 802.11n 400Mbps Access Points, Plug and Play, 3Mile Range, 48V PoE Injector Included

Spec Sheet
User Guide

$199.95

99 in stock

  • Ships in 1-2 days
  • No Risk Guarantee
  • 2-3 Year Warranty

FEATURES

BENEFITS

High Power Electronics and Powerful Antenna

Operation up to 3 miles with good line of sight and greater than 400 Mbps real world throughput

True Plug and Play

No driver needed. Pre-configured at the factory for automatic peer to peer communications

64 and 128bit WEP, WPA and WPA2 Encryption

Most powerful data security available

Web-based configuration

Remotely change device configuration or update firmware from anywhere on the network

Power over Ethernet

Antennas can be mounted up to 100meter (300’) from the power inserter

Layer 2 Transparent Bridge

Appears to network devices as if an Ethernet cable has been installed between the 2 network nodes. Passes DHCP, VOIP Packets, VLAN Packets and supports multiple MAC addresses

The EZ-Bridge AC is a dual radio high power (up to 22dBm) outdoor wireless bridge system operating in the 2.4GHz AND 5GHz unlicensed frequency spectrums providing real world throughput of up to 867 Mb/sec. The 2.4GHz radio complies with 802.3gn and the 5GHz radio complies with the 802.11ac/an standards to insure interoperability. The EZ-Bridge AC creates a transparent wireless bridge between two networks up to 3 miles apart with good line of sight and can provide a separate access point at one or both ends of the link via the 2nd radio. The EZ-Bridge AC supports VOIP, VPN, multiple MAC addresses and DHCP across the wireless link. It is the perfect plug and play solution for connecting high speed networks in two or more buildings, internet access sharing, remote video surveillance or remote network access. Multiple EZ-Bridge AC units can be connected in a mesh configuration to allow interconnecting more than two sites.

With its password verification, MAC address authentication, SSID suppression and advanced WPA encryption, the system provides the best available wireless data security.

Installation is a snap because of the plug and play features which have been built into the system. Just install the antennas and plug in the power inserters. The units will automatically find their peer and create a secure wireless network link. If changes to the pre-configured settings are desired, they can be easily done thru the built-in web interface from any point on either side of the network. There are no drivers or software that need to be loaded to the computer.

The EZ-Bridge AC comes complete with all the electronics that are needed for a point to point wireless network bridge installation; including 2 powerful dual band 12dBi 802.11gn AND 14dBi 802.11ac/an 2×2 MIMO antennas with built-in high power electronics, Bracket Kits which accommodate pole or wall mounting, Auto Ranging Gigabit rated 48V PoE (Power Over Ethernet) power inserters. Customer needs to supply CAT5 cabling between the power inserter and the antenna and between the power inserter and their computer, router or switch.

Weight 9.37 lbs
Dimensions 14 × 9 × 9 in

Firmware

Demo    Use “user” as the username and “password” as the password

3 reviews for EZBR-DUAL-AC

  1. Paul Tuz

    Great P2P system. Flawless Set up, ready to go out the box. Set up Side A and Side B, wait few minutes and you’re ready to go.

  2. Marco Palanco

    Bridged right out of the box. Changed password, and pretty much ready to go! Simple, straight foward. Now we go hang them. Thumbs up.

  3. Todd S

    I bought the EZ-Bridge-Dual wireless access point system to replace a weak wireless repeater I had set up in my garage, which is only 25 feet from my house. After looking at mesh systems and new wireless extenders, I decided on the EZ-Bridge-Dual. This equipment worked right out of the box. The documentation provided is excellent and I followed it step-by-step to confirm its operation via an initial setup in the house. Once the antennas were mounted and connected to the house internet, I set up a new router in the garage with a static IP after following some additional instructions that can be downloaded from Tycon Systems’ website. Thank you Tycon for this documentation. I now have a wireless network in my garage whose performance appears to be equal to what I have in the house.

Add a review

Join Our Waitlist We will inform you when the product arrives in stock. Please leave your valid email address below.