2.4GHz 802.11gn 100MB Point to Point Bridge, Plug and Play, 3Mi Range, 24V Wall Plug Passive PoE Injector Included
Key Features:
• Operation up to 3 miles with good line of sight
• Up to 100 Mbps throughput
• True Plug and Play
• Operating in the 2.4GHz unlicensed frequency spectrum
• Complies with the 802.11gn standards
$299.95
Customize
Store Qty
5 Features
High Power MIMO Compatible Electronics True Plug and Play 64 and 128bit WEP, WPA and WPA2 Encryption Web-based configuration Power over Ethernet Layer 2 Transparent Bridge Applications
Inter-Building Network Connectivity Wireless Backhaul for Internet Sharing Remote Video Surveillance Networks Mesh Networks for Multi-Site Campuses Industrial and Utility Communication Rural and Remote Site Connectivity Temporary or Rapid-Deployment Networks Short Description
2.4GHz 802.11gn 100MB Point to Point Bridge, Plug and Play, 3Mi Range, 24V Wall Plug Passive PoE Injector Included Long Description
The EZ-Bridge® LT+ is a high power 25dBm (316mW) outdoor wireless bridge system operating in the 2.4GHz or 5GHz unlicensed frequency spectrum providing real world throughput up to 100 Mb/sec. It complies with the 802.11gn or 802.11an standards to insure interoperability. The EZ-Bridge® LT+ creates a transparent wireless bridge between two networks up to 3 miles apart with good line of sight. It supports VOIP, VPN, multiple MAC addresses and DHCP across the wireless link. It is the perfect plug and play solution for connecting the networks in two or more buildings, internet access sharing, remote video surveillance or remote network access. Multiple EZ-Bridge® LT+ units can be connected in a mesh configuration to allow interconnecting more than two sites. With its password verification, MAC address authentication, SSID suppression and advanced WPA encryption, the system provides the best available wireless data security. Installation is a snap because of the plug and play features which have been built into the system. Just install the antennas and plug in the power inserters. The units will automatically find their peer and create a secure wireless network link. If changes to the pre-configured settings are desired, they can be easily done thru the built-in web interface from any point on either side of the network. There are no drivers or software that needs to be loaded to the computer. The EZ-Bridge® LT+ comes complete with all the electronics that are needed for a point to point wireless network bridge installation; including 2 powerful 14dBi 802.11gn or 16dBi 802.11an MIMO antennas with built-in high power electronics, Bracket Kits which accommodate pole or wall mounting, Cat5e rated POE (Power Over Ethernet) power inserters and 24VDC auto-ranging power supplies. Customer needs to supply CAT5 cabling between the power inserter and the antenna and between the power inserter and his computer, router or switch. Technical Links
Spec Sheet https://www.tyconsystems.com//specsheets/EZ-Bridge-LT-%20DataSheet.pdf User Guide https://www.tyconsystems.com//usermanuals/8000005%20Rev%2015%20EZ-Bridge-LT-%20quick%20install%20guide.pdf 